#Greddy emanage blue impreza update
#Greddy emanage blue impreza software

There's nothing you can do about it unless you switch over to stage 3 tuning, so you'll just have to ignore cold engine AFRs for now. Now because we're fooling the ECU with a reduced airflow signal you may find the stock ECU over compensating the cold engine and the AFR is showing 10.0 to 11.5 AFR. Start your engine, your idle AFR should be around 12.5-13.5 if your engine coolant is cold, but once warmed up the AFR should be around 14.7.For my PLX M300 I select OTHER, 10 and 20 for my AFR ranges. Next select A/F meter for Option 2, and fill in the correct attributes. Click on Parameter Settings, select Front Panel tab, Option 1 select Greddy Pressure Sensor (assuming that's where you plugged it in). If you have a greddy pressure sensor or wideband O2 sensor controller, now would be a good time to set it up.If you have a greddy pressure sensor, it might be easier for you to tune by PSI load scale instead. I recommend re-adjusting the load scale from 1500 max to something like 3000 max as 1500 is too low for our cars. You might have noticed the load scale is in airflow Karman Hz, this is actually preferable over throttle TPS% commonly used in emanage blue, Apexi SAFC, etc.People with a hot-wired overrun stock FPR will look closer to first airflow adjustment map above with -32% correction at idle. At low engine loads, you'll have to enrich, here's a general example of what I mean. This is because our stock MAF does not report airflow Hz in a linear fashion especially at low volume of air, so we cannot use a linear correction throughout the map as we just made earlier. Assuming you're still using a stock fuel pressure regulator that's not overrun, you'll find that -32% correction at idle is too much correction, and a good idle might be around -22%.Enter this correction value into the airflow adjustment map. For example my RC550 injectors would give a correction value of -0.32, multiply this by 100% and get -32%. Use the forumula (370/new injectors) - 1. Instead we need to calculate the correction factor ourselves. Any values you enter here are ignored because this is for stage 3 only. Don't make the mistake of using the I/J menu.With the engine off, just push the throttle all the way down and emanage will automatically fill in the settings for you for MIN and MAX. Click on Throttle tab and define MIN and MAX settings.

Click on Map Select tab and pick Airflow Adjustment map.Click on Vehicle tab, and select 6G72 engine code.

#Greddy emanage blue impreza software

Run software and Click on Parameter Settings (little blue car icon).

#Greddy emanage blue impreza update

Update to the latest software/firmware.

Jumper positions 1,2,3,4,5,6,18 doesn't really matter which position they are as we're not using the injector wires at this stage. Prerequiste: Ensure all emanage hardware jumpers are in their default position. Hardware: eManage ultimate, stage 1 wiring Goal: Utilizing the easiest tuning method on Emanage Ultimate by modifying the airflow signal only.